SpeeCo 580899 Instrucciones De Montaje Y Funcionamiento página 14

STEP 5E:
Slowly pull on the belt with the gauge in one steady motion until the hook side notches align with the top surface
of the other belt as shown. After aligning the hook side, check the top area of the gauge. When the handle side
notches align with the shown edge, then the belt being pulled is at the proper tension.
If the handle notches are above the edge,
then the belt is too tight and the tension
must be decreased. Move the engine
towards the tires to decrease tension.
STEP 5F:
Repeat this measurement on the other belt, tighten the engine mounting bolts, and re-check both belts to ensure
that they are still at proper tension. OVERTIGHTENING OF THE BELT WILL CAUSE PREMATURE WEAR AND
FAILURE OF THE CLUTCH ASSEMBLY, AND MAY CAUSE WEAR ON THE ENGINE SHAFT.
K1618
K1621
K1622
Page 10
K1620
If the handle notches are below the edge,
then the belt is too loose and the tension
must be increased. Move the engine
away from the tires to increase tension.
K1619
K1623
K1624