Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Congratulations!
Thank you for purchasing the HoMedics Hand Sanitizer. The Hands Sanitizer is one
of the most advanced products of its kind. Luxury meets practicality and hygiene
meets style:
- Motion sensor technology provides sanitary hands-free operation.
- Adjustable controller dispenses the right amount of soap or gel every time.
- Convenient magnetically attached drip tray removes easily for cleaning.
- Elegant functional design makes hand washing a pleasure.
IMPORTANT:
To avoid accidental dispensing of liquid, slide the Dispensing Control Switch to [OFF]
and install batteries before filling the Soap/Sanitizer Reservoir.
How To Install Batteries:
Press the [OPEN] release button on the underside of the unit to open the Battery/Control
Compartment door. Insert three (3) AA alkaline batteries carefully following the polarity
(+ / -) markings shown inside the battery compartment. Note: when the batteries are low
and need replacing, the red LED Low Battery Indicator will flash for 10 seconds after each
dispensing cycle.
CLEAN
Function
ON/OFF
Switch
Door Release
for Battery
and Control
Compartment
2
Caution: All
servicing of
this product
must be
performed by
authorized
HoMedics
Service
Personnel
only.
Dispenser Control
Switch for Amount
of Soap:
OFF/
1–LOW
2–MEDIUM
3–HIGH
How To Use
1. Lift the cover to the Soap/Sanitizer Reservoir and fill up to the "Full Line"
inside the tank. Do not overfill as this may cause dripping. Replace the plug in
the soap/sanitizer tank securely.
2. Press the [OPEN] release button to open the Battery & Control Compartment
on the bottom of the unit and slide the Dispenser Control Switch from [OFF]
to your desired amount of soap to be dispensed [1 = LOW], [2 = MEDIUM]
or [3 = HI]. The Red LED will turn on for 12 seconds. During this period, the
Motion Sensor and motor will not function. This will allow enough time to
close the Battery & Control Compartment door and position the unit without
triggering the Motion Sensor.
3. Attach the Drip Tray.
4. Place your hand under the spout to activate the Motion Sensor. The Hand
Sanitizer will then dispense liquid.
Spout
Red LED:
Indicates Motion
Sensor OFF During
Set-up; Flashes to
Indicate Low Battery
Condition
Motion
Sensor
3
Soap/Sanitizer
Reservoir
Drip Tray
Publicidad
Tabla de contenido
