Mr Handsfree Blue Smart Manual Del Usuario página 9

Table 1
A
Red wire
Black wire
Blue wire
Brown wire
• To avoid distortions, make sure that the cables are laid far away from the electronic systems of the car.
• Connect the wires with the contact clips. Put the car wire in the through groove of the clips and the cable wire in the
groove with the confining rib.
Attention!
If there is no "Ignition" wire or if it is unavailable, you should connect the blue cable wire to the red wire of the handsfree
unit and the red cable wire to the "Continuous" wire of the car which keeps the voltage when the ignition is turned off.
In this case, the phone call will not be disconnected if the ignition is turned off.
CAR RADIO MUTING (CRM)
The Blue Smart allows muting your car radio when there is an incoming call.
• Check the user's manual of your car radio and ensure that it has a Mute function. If additional settings have to be
set from the car radio menu, make sure that they are done correctly.
• Remove the control panel of the car radio.
• Remove the decorative panel and take the car radio out of the sleeve using the handles. Disconnect the car radio plug.
• Connect the wires of the mr Handsfree Blue Smart to the corresponding wires of the car jack or of the ISO jack of
the car radio according to Table 1. Use the contact clips for the connection.
• Restore connection and installation of the car radio.
3. Professional built-in connection: Immediately to the car's electronic system via system cable SC5 (Optional, available
separately).
• Disconnect the car radio and power leads.
• Join the cable according to the connection diagram shown below. If the car radio has a mute jack, connect the brown
wire of the SC5 cable to one of the "mute in" jacks (1, 2 or 3). Refer to your car radio manual to determine the posi-
tion of the mute jack.
The default connection is "mute 1". In case this is not corresponding with your car radio, your car radio will not show
"mute" on the screen. However, the sound on the speakers will still be disconnected from your car radio and con-
nected to your carkit during a phone call.
The indicated power connectors are for (+) plus and (+) ignition. In some cases (e.g. Renault) these connectors
need to be swapped.
The + voltage of the car's power supply
The negative GND connection
Ignition
Used for Car Radio Muting (CRM) and has to be connected to the car radio (Mute)
GB - 6
B