Jam Live Large Libro De Instrucciones página 3

SET UP
CHARGING YOUR EARPHONES
The "Live Large" earphones are powered by a
rechargeable battery. Please make sure to charge
earphones before use.
A – Unwrap the integrated charging cable and plug
the micro USB end into the charging port on
the earphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for your
cell phone or pick one up next time you're at
the store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 7 hours of play
time; while charging, the light will stay solid red.
Once fully charged, the LED will turn off.
USE
A – TURN ON YOUR EARPHONES
Long press the "play/pause" button for 3 seconds to
turn on your earphones.
B – CONNECTING TO A DEVICE
Once turned on, the earphones will immediately
search for a device to pair to; the LED will blink red
and blue alternately. Enable Bluetooth on your device.
From the Bluetooth menu, select "Live Large." When
the device and Live Large are connected, you will
hear a tone and the LED light will turn solid blue.
You may also connect your device to Live Large using
an aux cord, which is not included. When plugged in,
the light will turn solid red.
Once paired, your device and earphones will find each
other every time, as long as your device's Bluetooth is
on. If you're connecting to a computer, you may have
a few more steps on that end. You'll have to get that
information from the computer company.
3
Depending on your device, you may be prompted to
enter a pairing code. If so, use "0000" as the code.
Holding down the "X" and "O" buttons at the same
time, for 5 seconds, will disconnect a paired device.
EN