Commissioning - GRAVEDA GRASPRESSO ERIG DABTON Manual De Instrucciones

1. In order to remove any production and transport residues, we
recommend that you remove your Erig
Dabton® can be completely cleaned once, see page 9 Cleaning
instructions.
2. Charge the Erig Dabton® completely. Use the supplied USB charging
cable.
3. Now fill the glass top with water. The filling quantity should be approx.
1/3 of the glass atachment. Fill it with water until the level is between
the bubbler and the glass ball. Make sure that you do not fill too much
water into the glass atachment. Then carefully place the glass
atachment onto the basic unit.
4. Switch on the Erig Dabton®. Press the on/off buton 3 times. The device
will now switch on and is in standard mode.
5. Now set your desired temperature. The temperature can be displayed in
degrees Celsius °C or Fahrenheit °F. You can switch between these two
modes at any time. The temperature can be set in 1° steps. Press the +/-
keys at same time for 3 seconds.
6. Once you have set the desired temperature, press and hold the on/off
buton again to start the warm-up process.
7. The unit will now heat the Atomizer to the set temperature. Please note
that the Atomizer will now be hot! Do not touch it with your hands
anymore!
8. The Erig Dabton® automatically switches off the programme after one
minute.
9. Fill the bowl with the desired amount of Material, apply the Carb Cap
and pull slowly and steadily on the mouthpiece of the glass atachment.
10. Depending on the temperature, material and duration of the process,
you will achieve more or less steam.

Commissioning

Page 28