Debugging - GRAVEDA GRASPRESSO ERIG DABTON Manual De Instrucciones

Debugging

Page 29
The Atomizer must be synchronised with the device. If you unscrew the
atomizer, please note that it must be synchronised after it has been screwed
back onto the device.
This is done by holding down the On/Off buton and the Minus buton for
about 3 seconds. The display will now show the configuration number.
Please note that this procedure must be carried out every time you change
the Atomizer. This also applies to atomizers that have already been
synchronised but have been removed for cleaning.
Atomizer does not get hot:
The Atomizer was not synchronised.
ERROR:
The Atomizer is defective and must be replaced.
LOW VOLTAGE:
The batery is dead.
Drawing false air:
Air guide was not inserted correctly.
BAT ERROR:
When the batery is installed backwards.