Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Fastener Kit:
63070F
Pi & Cli
Pin & Clip
(Sold Separately)
Spindle Pin & Clip
1. Insert shank into hitch receiver and attach pin & clip (sold separately).
2. Insert tri‐ball assembly onto the shank, adjust to proper height and attach shank pin & clip.
(Height adjustment is in increments of 1.25 inches.)
3. Remove spindle pin & clip, rotate to select ball size or step, and reinstall spindle pin & clip.
Note: See Figure1 for maximum drop position and Figure 2 for maximum rise position.
Figure 1: Max. Drop Position
Note: Check for proper ball mount height with vehicle and trailer loaded for travel. At proper
adjustment the trailer coupler and tongue should be level with the ground. See Figure 5.
Note: check hitch frequently, making sure all fasteners are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
© 2013 Cequent Performance Products, Inc
Installation Instructions
Adjustable Tri-Ball Mount
Shank Pin & Clip
3
4
/
4
Figure 2: Max Rise Position
Figure 5: Proper Ball Height
Tri-ball Assembly
Shank
Sh k
11
5
/
16
Figure 3: Adjustable Step Position
Trailer Tongue Level
gu e 5:
ope
a
e g t
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
7
7
1
/
/
" Ball
2,000 Lbs (907 Kg)
8
2" Ball
10,000 Lbs (4535 Kg)
5
2
/
" Ball
14,000 Lbs (6350 Kg)
8
Dual Ball Mount
Figure 4: Storage Position Only.
DO NOT USE THIS POSITION
FOR TOWING
g
63070N
10-30-13
Form: F205 Rev C 9-17-2012
Part Number:
63070
(
)
P/N: 63071
Pintle Mount
P/N: 63072
Rev. B
Publicidad
Manuales relacionados para Cequent Performance Products 63070
Resumen de contenidos para Cequent Performance Products 63070
- Página 1 Note: check hitch frequently, making sure all fasteners are properly tightened. A hitch or ball which has been damaged should be removed and replaced. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. © 2013 Cequent Performance Products, Inc Sheet 1 of 3 63070N 10-30-13 Rev.
- Página 2 Nota : Vérifier l’attelage fréquemment, en s’assurant que toutes les fixations sont serrées adéquatement. Un attelage ou une boule endommagés doivent être enlevés et remplacés. Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. © 2013 Cequent Performance Products, Inc Feuille 2 de 3 63070N 10-30-13 Rev.
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. © 2013 Cequent Performance Products, Inc. Hoja 3 de 3...