Cequent Performance Products 63072 Instrucciones De Instalación

Fastener Kit:
63072F
Pin & Clip
(Sold Separately)
1. Insert shank into hitch receiver and attach pin & clip (sold separately).
2. Insert pintle mount onto the shank, adjust to proper height and attach shank pin & clip.
(Height adjustment is in increments of 1.25 inches.)
Note: See Figure1 for maximum drop position and Figure 2 for maximum rise position.
Tighten all 1/2-13 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M)
Figure 1: Max. Drop Position
Note: Check for proper ball mount height with vehicle and trailer loaded for travel. At proper
adjustment the trailer coupler and tongue should be level with the ground. See Figure 5.
Note: check hitch frequently, making sure all fasteners are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
© 2013 Cequent Performance Products, Inc
Installation Instructions
Adjustable Pintle Mount
Shank Pin & Clip
6 1 /
4
Figure 5: Proper Ball Height
Pintle Mount
Shank
4
Figure 2: Max Rise Position
Trailer Tongue Level
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Pintle Mount 14,000 Lbs (6350 Kg) GTW
Dual Ball Mount
1
/
4
Figure 4: Storage Position Only.
DO NOT USE THIS POSITION
FOR TOWING
63072N 10-30-13
Form: F205 Rev C 9-17-2012
Part Number:
63072
Tri-Ball Mount
P/N: 63070
P/N: 63071
Rev. B