Meccaniche Veloci Geneve Icon Manual Del Usuario página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Ancillary Crown
0 1 2
Position 0:
crown screwed
Position 1:
crown unscrewed
Position 2, time:
crown extracted, ready to set
the time
NOTE: when synchronising
minute hands of different
dials, a tolerance of maximum
45 seconds between minute
hands can be visible.
Setting the ANCILLARY dials
When setting any of the Ancillary Dials, the movement can
be stopped for better accuracy; in order to do so, unscrew
the Main Crown by turning it anti-clockwise from position 0
to position 1 without pulling it. Gently pull out the Main Crown
to position 2 and then to position 3. The Second hand will
stop moving. Then proceed as follows:
1) Unscrew the Ancillary Crown of the Ancillary Dial that needs to be
set by turning the Ancillary Crown anti-clockwise from position 0 to
position 1 without pulling it.
2) Gently pull out the Ancillary Crown to position 2 and turn it anti-
clockwise in order to set the time: hour and minute hands will move
forward.
When finished setting the time, gently push the Ancillary Crown
back to position 1 and then gently push and screw it in completely
into position 0.
Repeat step 1) and 2) for any Ancillary Dial to be set.
When finished setting the time of any Ancillary Dial, gently push the
Main Crown back to position 1 and then gently push and screw it in
completely into position 0. Further adjustments are possible without
stopping the movement.
Ancillary dials might occasionally require further adjustments over
time.
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Quattrovalvole

Tabla de contenido