Team kalorik TKG VT 1048 USB Manual De Instrucciones página 5

CHARGE AND BATTERY RECOMMANDATIONS
To charge the battery, follow these steps :
• Connect the input of micro USB cable to a USB plug or a charging adaptor.
• Connect the output to the plug at the back of the appliance's base.
• The LED indicator light will flash red while charging
• When the charge is complete, the LED indicator light will flash green.
• After the charge, always disconnect the USB cable.
Notes :
• The appliance won't charge is the cable is defective. Try another cable.
• While in use, when the battery is running low, the LED indicator light will flash red.
• While in use, when the battery is empty, the appliance will shut off and the LED
indicator light will flash flickering red.
USE
• To start the appliance, press the On/Off button for 3 seconds. The speed and natural
wind LED indicators will light up.
• To switch off the appliance, press the On/Off button for 3 seconds.
• Use the fan continuously for maximum 4 hours. Make a pause of minimum 1 hour or
until the appliance is completely cooled down before using it again.
Speed settings :
• There is 4 speed levels : low – medium low – medium high – high
• Set the desired speed by pressing the On/Off button : the speed LED indicator will
flash one more blade for each level.
• The natural wind mode mimics the feeling of a natural breeze and switch speeds itself.
You can activate it by pressing the On/Off button one more time after reaching the
4 speed level.
th
Vertical inclination (high-low) :
Adjust it up to 40° by orienting the appliance motor block in the desired angle.
CLEANING AND MAINTENANCE
•
Shut off and unplug the appliance before cleaning it.
•
Clean the appliance with a soft slightly damped cloth; do not use abrasive products.
•
Do not immerse in water or other liquid
•
Use a vacuum cleaner to remove dust and lint.
•
If the fan will not be used for long periods, it must be protected from dust and humidity.
5 TKG VT 1048 USB