Reelcraft LG3065 123 9Q Instrucciones De Operación

Operating Instructions
Retractable Industrial Extension Cord Reel
Model Numbers:
LG3065 123 9Q
CAUTION: Read all instructions and warnings before operating!
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
WARNING: To avoid serious injury or death from electrical
shock or fire.
DO NOT handle this fixture or try to plug it in when your
1.
hands are wet or damp or when you are standing on a wet or
damp surface or in water.
This fixture MUST ALWAYS BE USED in accordance with
2.
all electrical and safety codes and ordinances, including
the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Act (OSHA) Volume 1 on
General Industry Standards and interpretations.
3. ALWAYS make certain that the power source conforms to the
requirements on the fixture.
ALWAYS disconnect the power before servicing or inspecting
4.
the fixture for any reason.
5. This fixture is ONLY FOR USE ON 110-125V and is equipped
with an approved 3 conductor cord with a 3-prong, grounded
plug. TO REDUCE THE RISK OF ELECTRICAL SHOCK, it should
only be plugged into a properly grounded 3-prong outlet.
6. FIXTURE IS NOT WATERPROOF and is not intended for us
in showers, saunas or in potentially wet locations. ALWAYS
keep this fixture away from sinks, tubs, showers, etc. NEVER
attempt to pick up plugged-in power tools or appliances
should they fall into standing water. Fatal electrocution could
result!
7. This fixture comes equipped with a 3-prong grounded plug.
DO NOT remove the 3rd prong or otherwise try to modify the
plug. If it will not fit the outlet, have the proper outlet installed
by a qualified electrician. Improper connection of the ground-
ing conductor can result in a risk of electrical shock.
8. NEVER attempt to plug the fixture into a non-grounded outlet
or extension cord and ALWAYS be sure that the extension
cord is in good electrical condition.
9. This fixture is intended for use as a general indoor power
source. DO NOT use in potentially dangerous locations, such
as in flammable or explosive atmospheres.
10. Keep away from heating vents, radiators, or other sources of
heat.
11. KEEP OUT OF REACH OF CHILDREN.
INSTALLATION
All three screws with washers must be used when installing
mounting bracket. Eliminating one or more of the supplied hex
head screws may allow bracket to detach allowing reel to fall
causing damage to vehicles, injury or death.
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • reelcraft@reelcraft.com • www.reelcraft.com
LG3075 143 9Q
Wall Mounting
1. Pick the approximate location for the reel with 2 1/2 ft of a
2. Locate a stud to install the mounting bracket. The bracket will
3. Using the bracket as a template, mark the (3) screw locations
4. Pre Drill (Pilot) the three screw holes with the use of at 1/4"
5. Install the bracket with the (3) provided head wood screws
ELECTRICAL RATING
LG3075 143 9Q
LG3065 123 9Q
110-125V standard outlet.
be placed against the wall vertically, directly over the center of
the stud.
with pencil. (Fig. 1)
drill.The depth of the Pilot holes should be at least 2".
with washers using a 1/2" wrench or socket. Tighten all three
until snug. (Fig. 2)
3 1/4"
Bracket hole pattern
Fig. 1
Bracket A
Fig. 2
WARNING: DO NOT OVERLOAD! Check the amperages
of the tools or appliances to be plugged into the outlets
of the extension cord reel. Listed below are the maximum
amperage ratings.
Cord Cord Type /
Model
Length Gauge
75 FT 14/3 SJTOW
65 FT 12/3 SJTOW
3 1/4"
3 - #5/16" SCREWS
Maximum outlet rating
125V, 10 AMP, 1250 Watts
125V, 15 AMP, 1875 Watts
Rev: 9/2018