Publicidad
Idiomas disponibles
Idiomas disponibles
Laüka Dot
PU KNT 102 / PU KNT 104 / PU KNT 106 / PU KNT 108
PU KNT 112 / PU KNT 114 / PU KNT 116 / PU KNT 118
90mm
90mm
14mm
DINUY S.A.
C/Auzolan 2, 20303 Irún (SPAIN)
Tel.: + 34 943 62 79 88
E-mail: info@dinuy.com
www.dinuy.com
A
B
Fig. 1
Fig. 2
46mm
Fig. 3
2/4/6/8 - BUTTON KNX CAPACITIVE SWITCH
WITH TEMPERATURE AND LUMINOSITY SENSORS
AND THERMOSTAT FUNCTION
TECHNICAL DATA
KNX Supply Voltage
Power Consumption
Programming by
KNX Topology
Commissioning
Dimensions
Weight
Working Temperature
Storage Temperature
Degree of Protection
According to the Directives
According to the Standards
CHARACTERISTICS
2, 4, 6 or 8-tactile buttons glass capacitive switch which provide full control to the user
over the lighting, the blinds and, in turn, the ability to memorize scenes to generate
desired atmospheres at any time.
White or black glass.
Perimetral frame in copper color, in models with black glass, or in chrome, in models
with white glass.
Incorporates temperature probe and Cooling and/or Heating Thermostat function.
It incorporates luminosity sensor, as well as the twilight function.
Possibility of press confirmation by sounds.
KNX Bus Coupling Unit (BCU) integrated.
Commissioning by ETS5 or later versions.
DESCRIPTION
The pushbutton consists of different elements (Fig. 1):
· KNX bus connector (A).
· Programming LED and button (B).
MOUNTING AND INSTALLATION
Follow the steps below to install the pushbutton (Fig. 2):
1 - Place the plastic base in the mechanism box using the two screws included in the
packaging.
2 - Connect the bus line to the KNX connector (A) respecting the polarity.
3 - Press the push button on the plastic base, pushing it until it is perfectly tied.
DIMENSIONS (Fig. 3)
COMMISSIONING
NOTE: Download application software: www.dinuy.com
1 - Assign the physical address and set parameters with the ETS.
2 - Press the programming key and program the Laüka Dot pushbutton.
3 - After a sucessful programming the red LEDs (B) will be turned off.
14mm 13mm
30mm
WARNING!:
Installation and assembly of electrical equipment must be carried out only by a
skilled person!
Connect only to suitable supply voltage (KNX bus voltage)!
Installation and assembly of electrical equipment must be in accordance with
national building, electrical and safety codes!
GB
21 ~ 32V
DC
<10mA
ETS5
TP1
System Mode
90 x 90 x 14mm
165g
-5ºC ~ +45ºC
-30ºC ~ +70ºC
IP20 according to EN60529
Security 2014/35/EU
EMC 2014/30/EU
KNX Standard 2.0
EN60669-1, 2-1 & 2-3
Publicidad
