CONTENTS
SWING RIDE . . . . . . . . 4
PROPELLER RIDE . . . 16
Español . . . . . . . . . . . . . 29
Deutsch . . . . . . . . . . . . . 29
Svenska . . . . . . . . . . . . . 30
Dansk . . . . . . . . . . . . . . 31
Norsk . . . . . . . . . . . . . . . 31
Suomi . . . . . . . . . . . . . . 31
2
IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these instructions in a handy
location. They contain important
safety information.
Read all warnings and instructions
before you start to build and
operate the model.
WARNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
!
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
CAUTION: Be careful not to tip the model
over. Model should be placed on a flat and
hard surface.
•
Share the K'NEX experience with your child
and make building with K'NEX a family fun
adventure.
•
Take your time to enjoy the building process.
Don't rush!
•
While you're building make sure you face your
model in the same direction as the pictures
show in the instructions.
•
Be sure to install batteries into the motor
before you start building your motorized
models.
•
Product and colors may vary.
BATTERY INFORMATION
Caution: To Avoid Battery Leakage
•
Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions.
•
Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries. Only batteries of the
same or equivalent type recommended should be used.
•
Always remove weak or dead batteries from the product; do not
short-circuit supply terminals.
•
Insert batteries with correct polarity (+/-) as shown.
Important Tips
•
Alkaline batteries AA (LR6) are recommended.
•
Rechargeable batteries are not recommended.
•
Remove rechargeable batteries from toy before charging; they must
be charged only under adult supervision.
•
Non-rechargeable batteries must not be recharged.
•
Keep components free of dust; do not immerse or use in water.
•
Do not dispose of batteries in a fire; they could leak or explode and
cause injury.
•
Remove all batteries if the toy will not be used for a long period of time.
•
Do not put Rods smaller than 2 inches in any openings of the motor;
they will damage the motor, and cannot be removed.
How to Insert and
Remove Batteries
•
Use a small Phillips head
screwdriver to loosen the
screw. Insert 2 fresh AA
batteries (LR6) into the
compartment with the
correct polarity (+/-) as
shown here.
+
-