Cequent Performance Products 45513 Instrucciones De Instalación página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
1.
Install Rearward Most Fasteners – Insert (1) 1/2" carriage bolt and (1) spacer into the rearward most hole on each side through end of frame. One some models there are two holes at the rear most of the
frame. Use the smaller hole forward of the large hole.
2.
Raise Hitch into Position – Hold the hitch up under the frame with the bolts going through the holes in the brackets and install (1) 1/2" conical washer, (1) 1/2" lock washer, and (1) 1/2" nut on each side.
3.
Install Remaining Fasteners – Insert (1) 1/2" carriage bolts and (1) spacers through the remaining holes then install (1) 1/2" conical washer, (1) 1/2" lock washers, and (1) 1/2"nuts on the bolts as shown in
Figure 1. Some short bed models might need to have the forward most hole drilled. Use the holes in the bracket as a guide to drill a 1/2" hole in the frame.
4.
Tighten all 1/2" – 13 fasteners with torque wrench to 75 ft-lbs (102 N-m).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 45513, 45713, CQT45513
C-Frame
Possibly Drilled Hole
Forward
Figure 1
C-Frame
Sheet 3 of 9
45513N
Fastener Kit: 45513F
Qty. (6)
Lock Washer
1/2" Plated
Qty. (6)
Conical Washer
1/2"
Qty. (6)
Spacer
0.25" x 1.5" x 3"
Qty. (6)
Hex Nut
1/2" – 13
Qty. (6)
Carriage Bolt Gr5
1/2" – 13 x 2.00"
Fasteners Typical Both
Sides of Vehicle
Conical Washer
Teeth side
Against hitch
05-25-16
Rev. A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

45713Cqt45513

Tabla de contenido