Infiniton GAS4RO Manual De Usuario página 7

Instructions for use
The hob control area houses the devices and knobs for operation of the gas
burners and/or the electric hot plates.
Operation of gas burners
The burner regulation knobs can be turned anticlockwise from the closing
position to the widest open position and vice versa in the opposite direction
(put the needle to the position required):
= no gas supply
= maximum gas supply
= minimum gas supply
Lighting the burners
For models equipped with electrical ignition device, the ignition of burners
takes place by pressing and rotating the knob until the position of maximum
output is reached. In the versions with separate ignition key, only press this
key and at the same time press and rotate the knob proportional to the desi-
red burner, until it reaches the position of maximum output.
For versions without electric lighting (or if there is a power cut) perform the
operations described using a match or lighter to light the gas
(in such an
event, pay the utmost attention not to burn yourself).
For models with safety valve keep the knob pressed for about 3-4 seconds
until the device keeps the flame alight automatically.
The safety valve operates when the flame is turned off accidentally, stop-
ping the supply of gas (e.g. in draughts, spills of liquid, etc.).
The ignition device shouldn't anyhow be operated for more than 15
seconds.
If a burner is turned off accidentally or does not light, turn the control knob
OFF and repeat the lighting after at least 1 minute.
When the burner is lit adjust the flame as required.
To turn the gas supply OFF turn the knob clockwise to the << >> posi-
tion.
6 - ENGLISH