Grounding Instructions - noken ACRO COMPACT 100278528 Manual De Instrucciones

EN
you are connecting to the product, has been installed and protected to the installation standards in force at your coun-
try.
5. To install a product that is not equipped with a plug, a switch device that can completely disconnect the power supply
of the product must be installed at the front end of the fixed wiring.
6. When it thunders,it is strongly recommended to pull out the power plug.
7. Do not stand on ceramic toilet.
8. Do not stand on product unit,seat and cover.
9. Do not lean against the seat cover when using the product,to avoid damage.
10. This product is equipped with soft-closing seal cover.Heavy pressing or pushing may damage the soft-closing
damper.
11. Do not use lacquer thinner,petrol,liquid medicine,detergent,insecticide,toilet cleanser and scrubbing brush to clean
the product.
12.Exposure to direct sunlight is prohibited.
13.Only use tap water or potable water;otherwise it may cause chafing.
14.Do not connect water supply to heater outlet.Make sure inlet water temperature at 1~30ºC.
15.When the room temperature is under zero degree,please dry up the water tank,to avoid freezing.
16.Raise rest room temperature to prevent the toilet from damage due to freezing.
17.When move the product from cold or wet environment into normal room temperature,wait for 2 hours until the con-
densation water is fully volatilized.Doing so can prevent the product from electrical short-circuit.
18.When not using the product over three(3) days,drain the water from the hose and disconnect the power supply
19.Stop using the product and shut off the power when product malfunctions,please contact the service people for
professional service.
20. In case of abnormality or failure, please immediately disconnect the power supply, close the inlet Angle valve and
stop using.
The abnormal and fault conditions are as follows:
-The product is cracked or damaged
-Products smoking
-Abnormal sound and burnt smell
-Product heating anomaly
-Water seepage from inside pipes and products
21. Do not put your fingers or other objects into or block the drying outlet. Otherwise, it may cause scald, electric shock
or parts damage.
22. Do not hold the lid or ring to pick up the product. Otherwise make cause product damage.
23. Keep away the product from other devices using radiofrequency.

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
DANGER - Improper use of the grounding plug can result ina risk of electric stock
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.
5