Features; Assembly; Operation - Klutch NT18IW Manual Del Operador

pRoDUCT SpECIFICATIoNS
Motor ..................................................................18 Volt DC
Anvil .............................................................. 1/2 in. Square
Gear Train .......................................................... One speed
Switch .............................. (VSR) Variable Speed Reversible
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-556-7885 for assistance.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
AppLICATIoNS
You may use this product for the purposes listed below:
 Driving nuts and bolts using an impact socket
VARIABLE SpEED SWITCh TRIGGER
See Figure 1, page 9.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool oN, depress the switch trigger. To turn it
oFF, release the switch trigger and allow the tool to come
to a complete stop.
All manuals and user guides at all-guides.com

FEATURES

No Load Speed ................................. 0-3,000 r/min. (RPM)
Torque ..................................................................200 ft. lb.
Impacts Per Minute ......................................... 0-3,000 IPM

ASSEMBLy

opERATIoN

NoTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
DIRECTIoN oF RoTATIoN SELECToR
(FoRWARD/REVERSE/CENTER LoCK)
See Figure 1, page 9.
Set the direction of rotation selector in the oFF (center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward operation. Position the selector to
the right of the switch trigger to reverse the direction.
NoTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
6 — English
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
NOTICE:
To prevent gear damage, always allow the tool to come to
a complete stop before changing the direction of rotation.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when
installing or removing the battery pack, and when install-
ing or removing bits.