DeWalt DW624 Manual Del Usuario página 25

The distance between the top of the revolver
depth stop and the bottom of the fine adjuster is
the adjusted depth of cut.
• Tighten the clamping screw (15).
Triple depth adjustment using the revolver depth
stop (fig. E)
The revolver depth stop (20) can be used to set
3 different depths. This is particularly useful for deep
cuts, performed in steps.
• Place a depth template between the fine adjuster
(17) and the revolver depth stop (20) to adjust the
exact cutting depth.
• If required, set all three screws.
Make shallow cuts only!
Fine adjustment (fig. F)
When not using a depth template, or if the depth of
cut needs readjustment, it is recommended to use
the fine adjuster (17).
• Adjust the depth of cut using the fine adjuster (17).
One turn corresponds to approx. 1 mm.
• Read the depth of cut using the measuring lens
(12) and scale (13).
• Adapt the depth of cut to the millimeter using the
handwheel (11).
Depth adjustment with router installed in inverted
position (fig. D)
• Remove the cap nut (27) and the knurled knob (9)
and replace it with the height adjusting tool
(DE6966) available as an option.
• Screw the threaded end of the height adjusting
tool to the threaded spindle (7).
• Set the depth of cut using the adjuster on the
height adjusting tool.
For installing the Router in inverted
position, refer to the relevant instruction
manual on the stationary tool.
Fitting the parallel fence (fig. A & G)
• Fit the guide rods (6) to the router base (21).
• Slide the parallel fence (19) over the rods.
• Tighten the locking bolts (5) temporarily.
19
Adjusting the parallel fence (fig. A & G)
• Draw a cutting line on the material.
• Lower the router carriage until the cutter is in
contact with the workpiece.
• Tighten the plunge lock (14) and limit the carriage
return using the knurled nut (9).
• Position the router on the cutting line.
• Slide the parallel fence (19) against the workpiece
and tighten the locking bolts (5).
• Adjust the parallel fence using the fine adjuster (18).
The outer cutting edge of the cutter must coincide
with the cutting line.
• If required, loosen the screws (28) and adjust the
strips (29) to obtain the desired guiding length.
Fitting the baseplate extension (option) (fig. A & H)
When routing with large diameter cutters, it is
recommended to fit the baseplate extension
(DE6285) (22) for secure handling.
• Fit the baseplate extension to the free end of the
guide rods (6).
• Guide the tool with one hand on the knob (23)
and the other on the opposite grip (10).
Fitting a guide bush (fig. J)
Together with a template, guide bushes play a
valuable part in cutting and shaping to a pattern.
• Fit the guide bush (31) to the router base (21)
using the screws (32) as shown.
Connecting a dust extractor (fig. A & K)
The dust extraction adapter (33) consists of a main
section (34), a cover (35), a hose guide (36),
two screws (37) and two nuts (38).
• Slide the cover (35) onto the main section (34)
and let it click into place.
• Connect a dust extractor hose to the dust
extraction adaptor (33).
• Loosen the screw in the top of the router and fit
the hose guide (36) as shown.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Always move your Router as indicated in
fig. L (outer edges/inner edges).
E N G L I S H
en - 5