Installation Steps; Care And Cleaning - LUND Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Insert visor into window channel,
rear flange first. Rear flange inserts
between the trim and the exterior
suraface. The front & top flange
slides into the window channel.
3
Apply pressure to all flange edges to ensure proper
adhesion.
5
4 Piece Set
Install the rear visors using the same preparation methods as the front visor. Entire flange
final position
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of fit, durability,
finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
rear visor in
Repeat steps 1 thru 7 for remaining visors
branded products offered by Lund International. We take the utmost pride in our products and want
®
800-328-2438 • Visit us at lundinternational.com
© 2019 Lund, Inc. All rights reserved.
Lund and the Lund
®
Remove tape liner by pulling on free ends. Raise
window slowly and leave up for 24 hours to secure
4
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
6
slides inside window channel.
Lund International
logo are trademarks of Lund, Inc.
®
Page 2 of 2
visor to window channel.
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.