Installation Steps - LUND 26410014 Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Prior to beginning installation, attach U-nuts to each inner flange of the driver side running board as indicated.
x2
x1
x2
1
Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle and finding the holes in the rocker
panel. Note which holes correspond with the holes in the running board brackets. Mark the holes in the rocker panel with a grease pencil
or masking tape.
Front passenger side shown
2
Insert U-nuts into backside of rocker panel as shown, (5) per side. (2 front, 1 center, 2 rear)
3
Page 2 of 3