English - ChickenGuard EXTREME Manual De Instrucciones

ATTACH THE CONTROL BOX TO YOUR COOP
1. Attach the control box to the inside/outside of your coop.
(DO NOT USE A POWER DRILL)
2. Position the cord centrally to the top of the coop door.
3. Attach the cord to the top of the coop door (ensuring that you
maintain tension to prevent it from unravelling on the spindle).
Note: Allow 3-4 inches (7.5 – 10cm) gap between the bottom of the
control box and the top of the coop door, when the coop door is fully
open.
PLACE THE SEAL INTO THE FRONT PANEL
1. Remove the silicone seal from the zip lock bag.
2. Press the silicone seal into the recess around the edges of the
inside of the front panel.
3. Start from the bottom left hand corner and work your way round
the front panel.
4. Remove any excess length.
INSTALL THE 4 x AA BATTERIES
1. Install the batteries in the battery holder. Do not use 9V batteries.
2. Attach the battery connector to the battery holder.
CONNECT THE FRONT PANEL
1. Connect the red/black lead in the control box, to the prongs on
the inside of the front panel (with the black wire on top).
Note: If the red/black lead is connected the wrong way the UP and
DOWN will work in reverse.
chickenguard.com

ENGLISH

INSTALLATION
Do not use 9V batteries.
3