Velleman PCG10 Manual De Referencia página 3

PCG10 / K8016
FCC information for the USA
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Important
This equipment was tested for FCC compliance under conditions that include
the use of shielded test leads between it and the peripherals. It is important
that you use shielded cables and connectors to reduce the possibility of
causing Radio and Television interference.
Shielded probes, suitable for the PCG10 unit can be obtained from the
authorized Velleman dealer.
If the user modifies the PCG10 unit or its connections in any way, and these
modifications are not approved by Velleman, the FCC may withdraw the user's
right to operate the equipment.
The following booklet prepared by the Federal Communications Commission
may be of help: "How to identify and Resolve Radio-TV Interference problems".
This booklet is available from the US Government Printing Office, Washington,
DC20402 Stock No. 044-000-00345-4.
3