Treatment Session; After Your Treatment Session; Cleaning & Storage - TensCare perfect mamaTENS Manual Del Usuario

11.4. TREATMENT SESSION

1) Press and hold the ON button on the
control unit for 3 to 5 seconds to
switch the control unit on.
The LCD display will appear as A1
00 indicating that the unit has set
itself into Labour Pain Phase A and
Mode 1 at Zero intensity (00 mA).
2) You can now adjust the intensity of
the stimulation with the buttons ▲
and ▼ until you reach a comfortable
level. The LCD display shows the
strength of intensity.
3) Just remember
programmes A, B and C which you
can choose at any time as your
labour progresses, and when you
need a boost, just press the BOOST
button (see section 7).
Note: If the sensation becomes
uncomfortable,
intensity.
11.5. AFTER YOUR
TREATMENT SESSION
After use, press and hold the OFF
button on the control unit for 3 to 5
seconds to switch the control unit off
1) Once the unit off, remove the
electrode pads from your skin by
holding the pad itself and gently
pulling.
2) Replace the electrode pads to their
protective plastic shield and return
them to the re-sealable plastic bag.
Note: When
electrode pads, DO NOT PULL
ON LEAD WIRES.
the three
reduce the
removing the
19
Before the birth, you can use your
perfect mamaTENS to help with back
pain, and after with post birth pain.
Perfect mamaTENS can also be used
with the breast electrode pads* (see E-
CMR60130) to help initiate lactation.
* Sold separately
If you plan to put your perfect
mamaTENS into storage for your next
baby then do the following:
• Remove batteries
• Clean as instructed in section 12
• Store or throw away the electrode
pads with integrated leads
• Remember to buy new electrode
pads and batteries before you need
to use your perfect mamaTENS
again.
12. CLEANING &
STORAGE
Clean the case and lead wires after
each use by wiping with a damp cloth
and a solution of mild soap and water.
Wipe dry.
• Do
not immerse
machine in water.
• Do not use any other cleaning
solution than soap and water.
Storage life
• Storage life of an unopened pack of
self-adhesive electrode pads is 2
years. This may be affected by very
high temperatures or very low
humidity.
• The unit has no fixed shelf life.
your TENS