Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
"TARE" FUNCTION
Under this condition:
By pressing
, you can see the total weight of all loads on the scale. If you
want to weigh more loads,just press
5
The Tare function allows you to measure
items as they are added to the scale to get
separate and total weight of items.
1. Place first item(s) to weigh on the scale
and get weight.
2. Without removing item(s), press
to reset the LCD reading to "0".
3. Add the next item(s). The display will
show the weight of that item.
4. You can repeat this sequence until
you are done weighing items.
When the total sum of all items on
scale > 4% of scale's maximum weight
capacity, the Tare function is used.
(4%=80g when capacity is 2000g;
200g when capacity is 5000g)
The Tare function is active once the
T icon appears on the upper left corner
of the LCD screen.
to reset LCD reading to '0' again.
AUTO SHUT OFF
Auto shut-off occurs if display shows
'0' or shows the same weight reading
2mins 15sec
for 2 minutes and 15 seconds.
MANUAL SHUT OFF
To maximize battery life, press
to turn off the scale when you're done using it.
WARNING INDICATORS
1.Low batteries. Replace with new batteries.
1.
2.Maximum weight capacity (11 lb, 5000g) has
been exceeded. Remove items to prevent
2.
damage to scale.
6
Publicidad
Tabla de contenido
