B
21. Stand the unit upright.
22. Using the pilot holes as a guide, pick up one Door (J) and fasten the hinge bases onto the Left Side Panel (B)
with four 15 mm Zinc Screws (15) in each.
23. Repeat the procedure to attach the other Door (J) to the Right Side Panel (C).
24. Open and close the doors to make sure they are aligned and shut correctly. If necessary, adjust the screws
for a good fit. Refer to the hinge sticker on door for adjustment.
Assembly Instructions
A
J
x 16
DO NOT
23
B/ C
fully tighten the screws.
C
14
15
J