Cequent Performance Products 75049 Instrucciones De Instalación

Equipment Required:
Fastener Kit: 01130867
Wrenches: M19 Socket; M19 Wrench
Torque Wrench
Drill Bits: None
l
j
Qty. (6) Washer Conical, 1/2
k
Qty. (2) Bolt M12x1.25x35 CL8.8
1. Position hitch against frame rail and bumper bracket on left side and tiedown support on left side.
Remove tiedown hook if it interferes with hitch.
2. Install two M12 bolts with lock washers and serrated washers through top flanges of hitch into existing
weldnuts.
3. On drivers side install two M12 bolts with serrated washers from inside. Install M12 lock washers and
nuts from outside.
4. On passenger side install two M12 bolts with lock washers and serrated washers into weld nuts in
tiedown bracket.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Cequent Performance Products – Printed in Mexico
© 2002, 2014, 2015
Installation Instructions
Honda Passport
m
j
k
Tighten all M12 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Isuzu Rodeo
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
l
Qty. (2) Nut M12x1.25 CL8
m
Qty. (2) Locker, Split, Lock 12MM
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
DO NOT USE WITH
5000 (2270 Kg.)
Accessory Rating
N75049 03-25-15
Form: F205 Rev A 5-6-05
75049
44724
87500
Max Tongue
WT (LB)
SPRING BARS
500 (227 Kg.)
D
Rev. C