Cequent Performance Products 36602 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Teeth side
against hitch
Figure 3
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgroup.
com/qr-product.aspx
1. Lower the exhaust by removing (4) rubber hangers, and support the exhaust with a ratchet strap.
2. Scrape the undercoating at the bottom of frame on both sides. Fishwire 1/2" carriage bolt and spacer through the access hole and out the forward mounting hole. Reverse pull
fishwire 1/2" carriage bolt and spacer through the access hole. See Figure 2 for fishwire methods.
3. Raise the hitch above exhaust, feed fishwires through the attachment points on hitch brackets. (Pull back the rear fascia if needed to gain access between the fascia and exhaust
hanger.)
4. Remove the fishwires and secure the hitch with conical washers and hex nuts.
5. Tighten all 1/2" fasteners to 75 lb-ft. A universal joint socket may be needed to tighten the rearward fasteners on both sides.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
6. Reinstall the exhaust and remove the ratchet strap.
Note: Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch
or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 36602, 90249, 06948
Authorized Drawbar Kit:
36061 (Sold Separately)
Drawbar must be used in
the RISE position only.
FASTENERS TYPICAL ON BOTH SIDES
Rear
Figure 1
①
②
③
④
⑤
Sheet 3 of 15 36602NP
Fastener Kit: 36602F
Qty. (4) Carriage bolt
1/2" - 13 x 1.50 GR5
Qty. (4) Spacer
1/4" x 1" x 3"
Qty. (4) Conical washer
1/2"
Qty. (4) Hex Nut
1/2" - 13 GR5
Qty. (4) Fish wire
1/2" - 13
Pull wire procedure
Reverse pull wire procedure
Figure 2
09-21-15 Rev. A