Uline MONARCH 1110 Instrucciones página 2

PRINT ADJUSTMENT
1. Print location is correct when extreme righthand and
lefthand characters are located as shown.
Approx. 1/16 inch
Figure 9
FEEDWHEEL
BUTTON SLOT
3. Push feedwheel button in completely and turn
slightly clockwise if print is too far left or slightly
counterclockwise if print is too far right. Adjustments
made without completely depressing button are
temporary.
4. Repeat steps 2 and 3 until print is correctly
aligned.
REMOVE SUPPLIES
Figure 10
TEAR
TEAR
BACKING
PAPER
Figure 11
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
c
3 99
Approx. 1/16 inch
2. Place small coin in
feedwheel button slot.
(See Figure 9)
1. Tear label strip at label
roll as shown and pull
label roll from between
hubs. (See Figure 10)
2. Tear backing paper
strip. Pull label strip from
labeler. (See Figure 11)
3. Squeeze and release
trigger until backing
paper is free to be
pulled out. (See
Figure 11)
CLEAR JAMS, CLEANING AND LUBRICATION
Figure 12
BRAKE
REMOVAL
WHEELS
STRIP
FRONT
EXIT
2. Clear label track by squeezing trigger and feeding
label removal strip under brake wheels and out front
of labeler. (See Figure 12)
END OF
TRACK
Figure 13
4. If adhesive buildup occurs, lubricate with one drop
of a commercial 100% silicone lubricant as shown
with labels loaded.
Figure 14
LUBRICATE
Figure 15
LUBRICATE
NOTE: DO NOT OVER LUBRICATE!
1. With label roll removed,
check label track and
backing paper track for
stray labels.
3. To clear backing paper
track:
a. Insert label removal
strip in end of track
to loosen stray labels.
(See Figure 13)
b. Insert label removal
strip as shown, using
corner to remove
stray labels.
(See Figure 13)
LUBRICATE
One drop each side of
label chute between
spring and backing
paper. (See Figure 14)
LUBRICATE
One drop each spot
on backing paper
(total of four drops).
Spread with finger.
(See Figure 15)
0421 IH-707