Aqua Medic Ocean Runner OR 3500 Manual De Instrucciones página 8

If the pump is operated as a stand alone device, the connecting piece (Fig. 2, No. 17) should be
glued into the pump housing using PVC glue (e.g."Tangit") (OR 3500 only).
If the pump is used as return pump, it can be directly connected to PVC pipe. With the OR 3500 the
socket is removed and the pipe glued directly into the pump using PVC glue. The connecting piece
has to be removed then. If the pump is set up in this way, the pump head may not be less than 1
m. This method of plumbing gives the best results, see Fig. 1 (capacity). With all other pumps, a
PVC fitting (for dimensions see table 1) has to be mounted on the pressure fitting of the pump.
If a hard pipe is used for connecting the pumps, we recommend to use a short section of flexible
hose to avoid vibrations.
4. Exploded parts diagram
18
16
1
20
Fig. 2: Ocean Runner pumps
Parts List
1. Motor housing
2. Rotor / magnet
3. Impeller
4. Ceramic shaft
5. O-ring
6. Bayonet-lock
7. Lid of the
housing
8. Large washer
9. Small washer
10. 2 x rubber bearing
Available spare parts: Please refer to www.aqua-medic.de.
15
17
10
2
3
8
19 (4x)
11. Filter basket
12. Lid for the filter basket
13. Hose connection 1"
14. Washer 1"
15. Nut ¾"
16. Hose fitting ¾"
pump 17. Connecting piece
18. Washer ¾"
19. Rubber sucker (4 pcs.)
20. Bottom plate
4
5
6
9
7
Hose connection OR 3500
Hose connection for OR
6500:
15.
15a. Nut for hose connection
16.
17.
18.
21.
Hose connection OR 6500
11
12
14
13
Nut
Hose connection
Connecting piece
Washer
O rings (2 pcs.)