Using The Tool; Safety Information; Operational Safety - EGAmaster 58875 Manual De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY

USING THE TOOL

• Keep hands, loose clothing and long hair away from the reaction arm and working area
during operation.
• This tool will exert a strong reaction force. Use proper mechanical support and correct
reaction arm positioning to control these forces. Do not position the reaction arm so that it
tilts the tool off the axis of the bolt, and never use the swivel inlets as a reaction stop.
• Use only accessories recommended by the manufacturer.
• Use only impact sockets and accessories. Do not use hand (chrome) sockets or
accessories.
• Use only sockets and accessories that correctly fit the bolt or nut and function without tilting
the tool off the axis of the bolt.
• This tool is not insulated against electric shock.
• This equipment must not be operated or serviced unless the operator reads the operating
instructions and fully understands the purpose, consequences and procedures of each step.
Depending on the working environment, your local health and safety regulations may require
you wear protective gear (i.e. safety shoes, hard hat, gloves, coveralls, etc.). In case external
forces are exerted on the equipment, non-compliance with these regulations may result in injury.
EAR PROTECTION MUST BE WORN WHEN OPERATING THIS TOOL.

OPERATIONAL SAFETY

1. Inspect, maintain, operate and install the tool in accordance with all applicable standards
and regulations (local, state, county, federal, etc.)
Keep body stance
balanced and firm. Do
not overreach when
operating this tool.
Always wear ear
protection when
operating this tool.

SAFETY INFORMATION

Always wear
eye protection
when operating
or performing
maintenance on this
tool.
The Reaction Arm
must be positioned
against a positive stop.
Do not use the arm as
a dead handle. Take
precautions to make
certain the operator's
hand cannot be
pinched between the
arm and a solid object.
17