Lastolite Cubelite Instrucciones De Montaje

Setting up your
1
4
7
B
Cubelite Light Table
2
5
1. Remove items from the box. You should have:
3
- Bag containing the Light Table (flat)
- 4 x Black support rods
- Circular acrylic sheet
- Roll of translucent film
Remove the Light Table from the protective bag.
2. Lay the Light Table on the floor and position the end of
one of the rods on the corner of the lower steel rim.
Ensure the steel rim locates into the jaws of the tip at
the end of the rod.
3. Pull the two steel rims away from each other and locate
6
the jaws of the tip at the other end of the rod into the
upper rim.
4. Repeat steps 2&3 for the remaining three corners.
When all four rods are in place, check they are all in a
vertical position.
5. Place the circular acrylic sheet on the top of the Light
Table (Take care not to drop this sheet as it will
break).
6. The Light table is now ready to use.
7. Place your Cubelite on top of the Light Table and set
up your chosen lighting as required. Refer to the label
near the rear opening of the Light Table for advice on
how to position the light source inside. Attach the
translucent film that came with the Light Table kit inside
the Cubelite. This will allow the light from the Cubelite
Light Table to shine through.
Breaking Down your Cubelite Light Table kit.
8. Remove the translucent film, roll it up and return it to
the protective tube.
9. Remove the Cubelite from the top of the Light Table
and pack it away as per the instructions that came with
the Cubelite.
10. Remove and pack away your chosen lighting system.
11. Remove the circular acrylic sheet from the top of the
Light Table and return it to the protective bag.
12. Remove the supporting rods from the Light Table and
allow the two steel rims to lie on top of each other.
Return them to the protective bag.
13. Return all the Light Table items to the storage box.
02.07