hylite ecoheater HHT305 Instrucciones De Montaje Y Montaje página 3

IF FITTING TO A WALL
• Follow minimum clearances below and above the heater as shown in [Fig.4].
• Once a suitable location has been found, screw the two bottom halves of
the bracket to the wall (Fig.5).
• Place the Eco Heater on the brackets and then fasten top part of the
brackets over tube to secure.
DO NOT SWITCH ON THE HEATER UNTIL IT IS SECURED.
FIXING TO A FLOOR OR OPERATING THE HEATER FREESTANDING
• Follow the minimum clearances around the heater as shown in [Fig.6].
• If operating as a freestanding heater, fix brackets along the length of
the heater to adequately support the unit and ensure it is stable.
• Attach rubber boots to the feet of the bracket [Fig.7] to increase stability.
INSTALLING MORE THAN ONE HEATER
• Minimum clearances as shown in [Fig.8] must be observed when the
heater is in use.
2. OPERATION
• Ensure the power cable is pushed fully into the heaters power socket
before switching power on.
• Turn the thermostat knob in a clockwise direction until it reaches the
maximum setting [Fig.9].
• When the room has reached the desired temperature, turn the
thermostat knob in an anti-clockwise direction just until the appliance
switches off (amber yellow light goes out) and not beyond.
• The temperature will then be regulated and kept at a constant level by
the thermostat.
• The heater is fitted with a safety device which will switch off the heater
in case of accidental overheating (please see safety notes).
• To reset, disconnect the heater from the power source for a few
minutes to allow the unit to cool down.
• Make sure that any causes of overheating, such as obstructions, are
removed and plug the appliance in again.
• DO NOT DIRECTLY EXPOSE TO WATER
PLEASE NOTE: When the heater is switched on for the first time,
small wisps of smoke may drift from the heater. This is a perfectly
normal part of the first time operating procedure and should cease
after the heater has been operating for approximately 5 minutes
English
200mm min.
30mm min.
30mm min.
50mm
min.
30mm min.
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
50mm
min.
175mm
min.
30mm
min.
Fig.9