Control Pads On The Dehumidifier; Control Pads - Comfee MDDP-50DEN7 Manual De Instalación

CONTROL PADS ON THE DEHUMIDIFIER

CONTROL PADS ON THE DEHUMIDIFIER
NOTE: The control panel of the unit you purchased may be slightly different according to the models. Control pads
Clean filter indicator light
Comfort dehumidifying operation on
indicator light
Pump operation on indicator light

Control pads

When you push the button to change operation modes, the unit
will make a beep sound to indicate that it is changing modes.
PUMP Pad(on some models)
1
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is installed into the
unit and the continuous drain hose is removed from the unit
before the pump operation is activated. When the bucket
is full, the pump starts to work.Refer to the next pages for
removing the collected water.
Do not operate pump function at or below 0°C (32°F).
COMFORT Pad(optional)
2
Press to activate the comfort dehumidifying operation.
NOTE: On this operation, the unit can not be set humidity
level.
FILTER Pad
3
The check filter feature is a reminder to clean the Air Filter
for more efficient operation. The Filter light (Clean filter l ight)
will illuminate after 250 hours of operation. To reset after
cleaning the filter, press the Filter pad and the light will go off.
Press the filter pad for 3 seconds when the unit is on or off
to initiate the Wireless connection mode.The LED DISPLAY
shows 'AP' to indicate you can set Wireless connection
WiFi indicator light Auto defrost
operation 9on
indicator light
2
Fig.1a
1
Fig.1b
High fan
Continuous
indicator
Bucket full
operation on
light
indicator light
indicator light
Full
Auto defrost
On
Off
3 4 5
Defrost
On
Full
Off
and the compressor is forced off. If connection (router)
is successful within 8 minutes, the unit will exit Wireless
connection mode automatically and the Wireless indicator
illuminates and the compressor reverts previous state. If
connection is failure within 8 minutes, the unit exits the
Wireless connection mode automatically.
CONTINUE Pad
4
Press to activate the continuous dehumidifying operation.
TURBO Pad
5
Control the fan speed. Press to select either High or Normal
fan speed. Set the fan control to High for maximum moisture
removal. When the humidity has been reduced and quiet
operation is preferred, set the fan control to Normal.
Timer Pad
6
Press to initiate the Auto start and Auto stop feature, in
conjuction with the ◄ and ► key pads.
◄/►: Up/Down Pads
7
• Humidity Set Control Pads
The humidity level can be set within a range of 35%RH
(Relative Humidity) to 85%RH (Relative Humidity) in 5%
increments.
For drier air, press the ◄ pad and set to a lower percent
value (%).
12
Timer on/off
indicator light
9
6 7 8