Maintenance Instructions - Amika Brooklyn Heat Manual De Instrucciones

EN

Maintenance Instructions

Cleaning
The dryer is virtually maintenance-free. No lubrication is needed. For proper operating
performance, the dryer must be kept clean. When cleaning is needed, unplug the
cord, and clean dust and lint from air intake openings with a small brush or the brush
attachment of a vacuum cleaner. The outer surface of the dryer should be wiped clean
with a cloth only.
Blocked or clogged air intake vents will cause the dryer to overheat. If overheating
occurs, an automatic safety device will shut the dryer or the heat off to prevent damage
or personal injury. If the unit or the heat cycles off, unplug the cord and allow the
dryer to cool for 10 to 15 minutes before restarting. Make sure the air vents are clean.
Concentrators and Diffusers should be cleaned with a damp cloth.
CAUTION: never allow the power supply cord to be pulled, twisted, or severely bent.
Never wrap the cord tightly around the dryer. Damage will occur at the high flex
point of entry into the dryer, causing it to rupture and short. Inspect the cord frequently
for damage. Stop use immediately if damage is visible or unit stops or operates
intermittently. If the cord or dryer is damaged or does not operate properly, return it for
repair to an authorized service representative only. No repairs should be attempted by
the consumer.
Storage
When not in use, your dryer should be disconnected and stored in a safe, dry location,
out of reach of children. Do not wrap line cord around dryer. Allow the cord to hang or
lie loose and straight at the point of entry into the dryer.
4