HOW TO USE
Self-balancing electric scooter adapts dynamic equilibrium, using internal gyroscope and acceleration
sensors. The status of the electric scooter is controlled by the center-of gravity. And it is adjusted by motor
which is controlled by servo control system. When you lean forward, it will sense your actions to accelerate.
When you need to swerve, slow it down and move your foot forwards or backwards then the center-of
gravity of the body moves left or right therefore the scooter can realize left or right.
Forwards
Backwards
Self-balancing electric scooter has inertial dynamic stabilization system, so it can keep anterior-posterior
balance but cannot guarantee the left and right. So, when swerved, the scooter need operating slowing,
otherwise, you may get injured because of the large centrifugal force.
Step 1: Press the power switch to turn on self-balancing electric scooter. A green light will come on to indicate
that the product is on.
Step 2: Firstly, step on one foot trigger the foot-switch, the system will come into self-balancing condition.
Then step on the other foot to operate it.
Step 3: Take control of the scooter forwards or backwards, do remember magnitude of your body shouldn't
be violently.
Step 4: Control the left and right direction of the scooter.
Step 5: Get off. Before you get off, make sure that the scooter is still, then step off one foot, finally the other
foot.
NOTE: If the user exceeds the maximum speed, or if the Segway is not used correctly (non-horizontal
platform), the latter will sound an alarm tone (the same as on ignition).
When using the product, if it has almost no battery, a beep will sound (the same as the ignition). It will then
load the product.
When the power is low, there is not enough power for normal driving, do not continue to use the product, it
is very easy to fall and it will also affect the life of the battery.
When you switch on the Segway, you will hear an audible signal, which means that the warning devices, seen
above, function correctly.
4