Flamelux PARIS Manual De Propietario página 11

FUNCTION
POWER
HEATER
ECO
BOOST
TIMER
BRIGHTNESS
FLAME MODE
FLAME SPEED
CHILD SAFETY
LOCK
OPERATING INSTRUCTIONS
ICON DESCRIPTION
This button will not only put the fireplace insert in a standby mode, but also you can
see the flame effect through the screen. This will turn off all functions at once.
The fireplace contains a fan forced heater.
The default setting temperature is 72°F (22°C).
The thermostat setting range is 50°-86°F or 10°-30°C.
The thermostat is adjustable by 2°F or 1°C increments.
To change between °F and °C press and hold the HEATER button for 5 seconds.
Press the ECO button when the heater is on, to run the heater in a reduced wattage
range.
NOTE: Holding the ECO button for 3 seconds disables any heater functions.
To quickly heat up a cold room/space, press the BOOST button to run the heater at
the full rated wattage.
Pressing the BOOST button repeatedly will cycle through the following boost settings:
5 minutes, 10 min, 15 min, 20 min, 25 min, 30 min and off.
Pressing the timer button repeatedly will cycle through the following timer settings:
30 minutes, 1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr, 8 hr and off.
The fireplace will automatically turn off when the timer reaches zero minutes.
Brightness is adjustable from remote control only.
This button controls the brightness of the flame effect.
5 different flame effects are available:
1. Snow White
2. Rubine
3. Ocean
4. Provence
5. Party
Party: In this mode, the unit will cycle automatically between all flame effects
periodically.
The flame speed is adjustable from remote control only.
Flame speed range: setting 1 the slowest to setting 5 the fastest.
The child safety lock is adjustable from remote control only.
Holding the child safety lock button for 3 seconds disables or enables all functions on
the control panel and remote control.
E-10