Lenco BOOST-8 Manual De Instrucciones página 4

POWER SUPPLY
 BATTERY OPERATION
1. Remove the battery compartment cover gently.
2. Install 8 x 'D' size batteries (UM-1 or equivalent) while observing the correct polarities.
3. Replace the battery compartment cover.
NOTE:

The AC cord must be detached from the AC socket of the player.

Leaking batteries may damage the battery cabinet and the player as a whole, so they should be
removed from the cabinet when becoming flat or when the player is not to be played on batteries for
some time.
 AC OPERATION
Insert the AC cord to the AC socket of the player, and plug the other end to an applicable wall outlet.
NOTE: During playback, if no audio input to the unit and not any operation in about one hour, the unit
will switch to standby mode automatically.
BACKUP POWER FOR CLOCK
Two AA/R6 size batteries are required for the backup power for the clock. Follow the instructions of
"BATTERY OPERATION" to install the batteries.
STEREO HEADPHONES JACK
A stereo headphones jack has been provided at the back of the unit so that you can enjoy music
without disturbing others. To use this jack, plug in the headphones/earphones (3.5mm in diameter, not
included) and adjust the volume to a comfortable level.
NOTE: When external headphones/earphones are connected, the sound to the unit's main speakers
will be made mute.
AUX IN
Follow the below steps to connect the unit to another audio device such as MP3 player and the like:
1. Connect the Phones jack of the MP3 player or Audio Out jack of other audio device to AUX IN jack
on the back of the unit with an audio cable.
2. Press the STANDBY button to turn the unit on.
3. Press the FUNCTION button on the unit repeatedly or press AUX IN button on the remote to switch
the unit to AUX mode.
4. Operate the external audio device to start playback.
To PHONE jack
EN-3