NEVER USE THE HIGH CHAIR WITHOUT THE TRAY T-BAR (PART R) PROPERLY INSTALLED.
!
WARNING: The child MUST be secured in the high chair at all times by the harness system. The tray is not designed
to hold the child in the chair.
TO INSTALL TRAY T-BAR: Slide the Tray T-bar (part R) into groove on bottom of the Main Tray (part N) until the
locking tab snaps into place ❶. Pull gently on the Tray T-bar to ensure it is secured in place.
TO REMOVE TRAY T-BAR: Press down on the locking tab and remove.
The Insert Tray (part O) comes already inserted.
TO REMOVE INSERT TRAY: Lift tabs on both sides and pull up.
TO INSTALL INSERT TRAY: Snap both tabs into place on the Main Tray (part N) ❷ .
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
ENSURE HARNESS SYSTEM IS SECURE BY PULLING ON IT. CHECK FREQUENTLY. ALWAYS ADJUST HARNESS SNUGLY AROUND YOUR
CHILD.
!
ALWAYS USE THE CROTCH STRAP IN COMBINATION WITH THE WAIST STRAPS.
!
ALWAYS SECURE THE CHILD IN THE RESTRAINT TO AVOID SERIOUS INJURY TO YOUR CHILD FROM FALLING OR SLIDING OUT.
Securing child with 5-point or 3-point harness (part M):
1. With the crotch strap between the child's legs, secure both buckles as shown ❶.
2. Adjust the harness so that it fits snugly around the child without causing discomfort. Slide the adjusters on the Shoulder, Waist and Crotch
Straps to tighten or loosen the harness system. To loosen Waist Belt, press buttons on the sides of the buckles as indicated ❷.
TO RELEASE HARNESS: Press the large button in the center of the harness buckle ❸.
TO CONVERT TO 3-POINT HARNESS:
1. Lift Chair Pad off Chair Back.
2. Using a screwdriver, unscrew both shoulder belt harness straps from backrest.
3. Feed belt ends through Chair Pad and undo shoulder belt straps from adjustment clip and buckle.
4. Store shoulder belt straps, adjustment clips and screws with washers for future use.
M
5-point
5
TRAY ASSEMBLY
WARNING!
!
DEATH OR SERIOUS INJURY CAN OCCUR
HARNESS SYSTEM
WARNING!
!
WARNING!
!
❶
M
3-point
❷
❸
❶
R
❷
O
N