Hardware Installation - Intellinet 522328 Manual Del Usuario

Gigabit PCI Network Card • User Manual
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS
522328. For specifications, go to www.intellinet-network.com.

HARDWARE INSTALLATION

1. Turn your computer off and disconnect its power
cord from any power outlet.
2. Remove the computer cover.
3. Remove the rear cover plate from an available PCI
slot.
4. Insert the card and screw it firmly in place.
5. Replace the computer cover and plug the
computer back into a power outlet.
Once the card's RJ45 port is connected to an active network device, the LEDs will light to indicate
link activity and speed.
SETUP
For Windows 2000/XP/2003 (32/64 bit)
At startup, these Windows operating systems automatically detect the card and install it with built-
in drivers. For Windows XP with Service Pack 2, follow these steps.
1. If the Found New Hardware screen displays at startup, click "Cancel" to postpone the driver
installation at this point.
2. Insert the included driver CD into your CD-ROM drive.
3. On the desktop, click "Start, " then click "Run. "
4. Enter "D:\LAN\RTL8169_8169S(B)_8110S(B)\Setup.exe" (where "D" or any other letter
corresponds to your CD-ROM drive). Click "OK. "
5. Follow the on-screen instructions to complete the installation, then re-start.
For Windows Vista/7 (32/64 bit)
At startup, Windows Vista/7 automatically detects the card and installs it with its built-in driver. To
upgrade the Vista or Win7 built-in driver, follow these steps.
1. Insert the included driver CD into your CD-ROM drive.
2. On the desktop, click "Start, " then click "Run. "
3. • For Vista, enter "D:\LAN\RTL8169_8169S(B)_8110S(B)\Vista\setup.exe" (where "D" or any other
letter corresponds to your CD-ROM drive). Click "OK. "
• For Win7, enter "D:\LAN\RTL8169_8169S(B)_8110S(B)\Win7\setup.exe" (where "D" or any other
letter corresponds to your CD-ROM drive). Click "OK. "
4. Follow the on-screen instructions to complete the installation, then re-start.
VERIFYING SETUP
For Windows 2000/XP/2003
Go to Control Panel, then System Properties. Click "Device Manager. " The installation was successful
if "Realtek RTL8169/8110 Family Gigabit Ethernet NIC" is listed under Network Adapters.
For Windows Vista/7
Go to Control Panel, then System Properties. Click "Device Manager. " The installation was successful
if "Realtek PCI GBE Family Controller" is listed under Network Adapters.
2
ENGLISH
Gigabit PCI Network Card, Model
™
Link/Activity
English
RJ45
port