Operation - Bell'O 36II100GRG Manual Del Usuario

Operation (continued)

Operation

- Powering the Fireplace
Push the Power button to supply power to all
functions of the fireplace and put the insert in a
standby mode.
Push the Power button again to turn off all functions.
NOTE:
All previous settings are held in memory, so the
next time you power up the fireplace, the unit will turn on
with the same settings.
NOTE:
Holding the Power button on the control panel for
10 seconds will disable the heater function.
- Adjusting the Heater
To set the thermostat use the heater button on the touch
control panel to select the desired temperature. The heater
button on the remote will turn the heater on/off to the
thermostat setting selected by the control panel.
The thermostat setting range is 62°F - 82°F or 17°C - 27°C
or always ON.
The thermostat is adjustable by 2°F or 1°C increments by
pressing the up or down buttons.
NOTE:
To change between °F and °C press and hold the
Heater button on the control panel for 3 seconds.
- Adjusting the Uplights
Pressing the uplights button will change the uplight between
the five settings: white, blue, white/blue, auto-cycling and OFF.
A1135
- Adjusting the Spectrafire Flame
There are six brightness levels that can be selected.
Settings 6 - 4 decrease in Spectrafire brightness.
Settings 3 - 1 decrease in Amber only flame brightness.
- Adjusting the Sidelights
Pressing the sidelights button will change the sidelight
between the five settings: amber, blue, blue/amber,
auto-cycling and OFF.
- Setting the Timer
Press the Timer button to cycle through the ten timer
settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H and 9H) and the OFF setting.
24
www.tsicustomerservice.com