Pulley And Flywheel — Alignment; Storage - Craftsman 919.157251 Manual Del Operador

Figure 10
6. Hold belt tension until two engine mounting screws
are tightened securely.
7. Tighten remaining engine mounting screws, saddle/
stiffener plate screws, handle set screw and
stiffener bar nut.
8. Reinstall belt guard and screws.
Before You Store The Air Compressor
1. Review the "Operating Procedures" and
"Maintenance" sections on the preceding pages and
perform maintenance as necessary. Drain the water
from the air tank.
2. Review the Briggs & Stratton "Operating and Mainte-
nance Instructions".
D20396
Once the engine pulley has been moved from
its factory set location, the grooves of the
flywheel and pulley must be aligned within
1/16" to prevent belt wear.
Pulley and Flywheel — Alignment
The compressor flywheel and motor pulley must be inline
(in the same plane) within 1/16" to assure belt retention
within sheave grooves. To check alignment, disconnect
spark plug wire and remove the beltguard. Place a
straightedge against the outside of the flywheel and
measure the distance from it to the nearest groove.
Alignment is achieved when the other end of the straight-
edge is within 1/16" of the measured dimension at the
pulley grooves. Squareness is achieved when the pulley
grooves are an equal distance from the straightedge on
both sides of the motor shaft.

STORAGE

3. Remove the air tool or accessory.
4. Protect the air hose from damage (such as being
stepped on or run over). Wind it loosely around the
outfit handle.
5. Store the compressor in a clean and dry location.
14 - ENG
NOTE