AEG SOLO 10 Manual Del Usuario página 6

5
4.5 Text and Number Entry
The following table shows you how to enter characters, by using repeated presses of the alphanumeric
keypad. This will be helpful when storing a name in the phonebook or renaming your handset.
For example, to enter the name Tom:
T Press 8 once
O Press 6 three times
M Press 6 once
In editing mode, a cursor is displayed to indicate the current text entry position.
It is positioned at the right of the last character entered.
Writing Tips:
Once a character is selected, the cursor will move to the next position after a short pause.
Press to delete the last letter or number.
5 SET THE DISPLAY LANGUAGE
You can select different display languages.
• From the home screen, press
• Press to "PERSONAL SET" and then press
• Press to "LANGUAGE" and then press
• Press to select your preferred language and then press
> A confirmation beep is played.
• Press to return to standby mode.
Note:
Once the display language is set, the handset will switch to display in the selected language immediately.
6 USING YOUR PHONE
6.1 Make a Call
6.1.1 Pre-dialling
• Enter the phone number (maximum 24 digits).
• If you make a mistake, press
• Press to dial the phone number.
6.1.2 Direct Dialling
• Press .
• Dial the number (maximum 24 digits).
Note:
If you make a mistake, you cannot correct it with the
Press and then press
6.1.3 Call from the Redial List
• Press key in standby mode.
> The last number dialled is displayed.
• Press to select the desired entry in the redial list and then press
number.
.
to delete the last entered number.
to return to the home screen.
to select.
to select.
to confirm.
key.
to dial out the selected redial