Kohler K–2001 Manual Del Usuario página 4

2. Install the Console Table and Lavatory
Turn the adjustable feet so they are all the way in.
Move the console table into the desired installation location, and
carefully lift the lavatory onto the console table. Move the console
table as needed so the lavatory is against the finished wall.
Mark the finished floor where the four adjustable feet make
contact, and remove the lavatory and console table from the area.
Drill 1/4" holes about 1/2" (1.3cm) deep at the four marked
locations on the finished floor.
Reposition the console table and lavatory so the console table
adjustable feet are in the drilled holes in the finished floor.
Check the console table and lavatory for level, and turn out the
console table adjustable feet as needed. Make sure the console
table rests on all four feet.
Locate the two lavatory anchoring holes, and mark the hole
locations on the finished wall.
Carefully remove the lavatory from the console table. Then move
the console table from the area.
Drill 1/4" mounting holes at the marked locations on the finished
wall and the finished floor.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install hanger bolts to the backing material so each bolt extends
approximately 1-1/4" (3.2cm) from the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
1020532-2-A 4 Kohler Co.