BH 0190608 Manual Del Usuario página 9

If the pulse rate is above the target
value the monitor will give out warning
beeps and reduce the exertion settings
by one level every 15 seconds until it
reaches the minimum 1. If the pulse rate
still stays above the target value for
more than 30 seconds the monitor will
beep and stop in order to protect the
user.
To program time, distance, and/or
calories, go through the following
procedure: Once the heart rate program
has been selected and before pressing
the START/STOP
ENTER key to program the time limit
using the UP▲/DOWN▼ keys. Press
ENTER again to program the distance.
Press the ENTER key one last time to
program the calories.
Press START/STOP
exercise. Your hands must be placed
on the pulse sensors (R) when using
these programs.
RANDOM FUNCTION.-
Use the UP▲/DOWN▼ keys to select
the P13 RANDOM function.
Press START/STOP
exercise.
To program time, distance and/or
calories, go through the following
procedure: Once the program has
been selected and before pressing the
START/STOP key, press the ENTER
key to program the time using the
UP▲/DOWN▼ keys. In this case the
time will be divided into 10 stages.
Press the ENTER key to program the
distance. Press ENTER again to
program the
START/STOP to start the exercise.
You can vary the exertion level during
the exercise
UP▲/DOWN▼ keys.
key, press
to start
to start
calories. Press
by pressing
HAND-GRIP
MEASUREMENT INSTRUCTIONS
– USE.-
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig.2.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
the
If both hands are not placed correctly
as shown in Fig.3 then the pulse
function will not work. If a «P» appears
on the screen or the heart symbol does
not flash, make sure that both hands
the
are placed correctly on the sensors.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection
cable is connected.
the
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a.- Unplug it from the 220 V mains
socket for 15 seconds and then plug it
back in.
b.- If the above steps do not help then
replace the electronic monitor.
the
9
PULSE Hand-grip.
for
PULSE
a particular