7
INSTALLATION
1. Position battery in battery tray and fasten securely to vehicle.
2. Connect terminals properly: A. Pos(+) cable from ignition to
Pos terminal; B. Neg (-) cable from engine or chassis to
Neg terminal.
MAINTENANCE SERVICE
A battery not in use can run down and create sulfate deposits.
After your battery has been filled and charged, it is essential that you
keep it adequately charged either by running the vehicle or by using
an independent battery charger. If charging is required, use a 1 amp
slow charger overnight to return the battery to full charge. It is not
recommended to use an automatic shutoff charger / tender for
prolonged periods. This will cause premature failure and shorter life.
WINTER STORAGE
Clean battery case and terminals with baking soda and water,
and make sure battery is fully charged before storing.
Store in a cool, dry location (not next to a furnace or other heat
source). Check charge every 45-60 days (see Maintenance Service,
above).