Technical Data; General Safety Informations - BGS technic 6655 Manual De Instrucciones

TECHNICAL DATA

Material: Polyethylene (PE)
Capacity: 1000 ml
Operating pressure: 6.3-8.2 bar (90-120 psi)
Air consumption: 57 l/min
Air inlet: 1/4"
Air hose inner diameter.: min.10 mm (3/8")
Weight: 700 g
WARNING!
Read, understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty.
When using tool, basic safety precautions should always be followed to reduce the risk of personal
injury and damage to equipment.

GENERAL SAFETY INFORMATIONS

1. Caution:
Maintain a safe working environment. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work area free of
obstructions, grease, oil trash, and other debris. Do not use the unit in areas near flammable
chemicals, dusts and vapors.
2. Observe work area condition:
Do not use this unit in damp or wet locations. Do not expose to rain.
3. Keep children away:
Keep children out of work area. Children must never be allowed in the work area. Do not let
children play with this tool or it's packing. Keep the tool out of reach of children.
4. Store equipment:
When the air tool is not in use, the tool must be stored in a dry location and out of children reach.
5. Use the right tool for the job:
Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There
are certain applications for which this tool was designed. lt will do the Job better and more safety at
the rate for which it was intended. Do not modify this tool and do not use the tool for a purpose for
which it was not intended.
6. Maintain tools with care:
Keep tools maintained and clean for better and safer performance. Follow instructions for cleaning
and changing accessories. Check air pressure hoses and fittings periodically. If there is any
damage, you have to repairing them by a qualified technician. The handle must be kept clean, dry
and free from oil and grease at all times.
7. Check for damaged parts:
Before using this tool, any part that appears damaged should be carefully checked to determine
that it will operate properly and perform its intended function. Check for alignment and binding of all
moving parts. Renew broken parts and eliminate any other condition that may affect proper
operation. Any damaged parts should be properly repaired or replaced by a qualified technician.
Do not use the tool if the trigger does not operate properly.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Pneumatic Soda Spray Gun, 1L
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6655
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed