dormakaba BEST Switch CORE Instrucciones De Instalación página 2

Sw i tc h ™ C o re I n sta l l at i o n I n st r u ct i o n s
3
CORE ORIENTATION
Control lug
retracted
The hex key (H) should come inserted in the core (E) with the control lug retracted. If so, go to step 5. Otherwise, go to step 4
to retract the control lug.
4
RETRACT CONTROL LUG
Lobe
Knob
E
Rotate the knob to align the hole in the circuit
board with the control access hole in the core (E).
5
INSERT CORE
Align the throw member (B) with the lock and insert the core (E).
BEST is a trademark of dormakaba USA Inc.
NOTE: The core (E) must be in installation mode for the hex key (H) to access
the control lug. If not, the hex key (H) cannot be rotated. If this is the case,
please reference the Switch™ Tech user guide for further instructions.
https://support.bestaccess.com/hc/en-us/articles/360036366673
Hole
E
Insert the hex key (H). Then gently push and rotate the hex key (H)
counterclockwise to retract the control lug.
Control lug
shown retracted
A
B
H
E
Control lug
extended
Control lug
shown extended
H
2/24
E
H
Control lug
shown retracted
E
H
A
E
NOTE: Insert throw
member (B) in core
if needed.
T91407_A ©2020 All rights reserved.
H