Before You Start - Haiku S3127-X2 Serie Manual Del Usuario

BEFORE YOU START

☑ Turn Off Power
Contact a licensed electrician
if you are uncomfortable
performing electrical work. A
licensed electrician must install
the fan if required by local code.
Do not use the fan with a
dimmer switch.
Turn off power at breaker!
☑ Gather Tools
☑ Prepare Fan Site
Mounting: Sloped or flat ceilings from 11 to 18 feet (3.4 to
5.5 meters)
Input Voltage: 100–240 VAC, 50–60 Hz
Outlet Box: Make sure your outlet box is suitable for fan
support. If there is not an outlet box at the fan location,
install one on a ceiling joist or beam.
Concrete Ceiling: Install an anchor hook for the safety
cable if required by your local building and safety code. See
the following page for installation details.
Wood Ceiling Joist: Attach the mounting bracket directly
to the joist using two wood screws (not supplied). Big Ass
Fans recommends using corrosion-resistant 12-11 x 45 mm
hex head timber screws with seal.
☑ Select Extension Tube
Select the appropriate extension tube for your ceiling
height and slope. See page 2 for a guide to select the most
appropriate extension tube.
READ AND SAVE THESE INSTRUCTIONS
HAIKU® BY BIG ASS FANS | REV. A | 06/17/2020