Installing And Charging The Battery; Status Led - Veho Smartfix VFS-014-SF Manual De Instrucciones

English

3. Installing and charging the battery

1. Insert the battery into the base of the scanner.
2. Connect the Mini-B USB cable to the rear of the scanner, then plug the other end of the
USB cable into a USB port on a computer or 5V/1A AC Adaptor.
3. When charging, a red LED will light up. When the battery is fully charged, the red LED
will turn off.

4. Status LED

Red The Veho Scanner is turned off and the battery is charging.
Purple The Veho Scanner is turned on and the battery is charging.
Blue The Veho Scanner is turned on.
5. Inserting Slides or Negatives into the holder
1. Place the holder so the glossy side faces up.
2. Open the holder as illustrated.
4
3. Put a slide/negative into the holder as shown.
4. Close the holder, making sure that the tray closes correctly.
6. Using the VFS-014-FS
1. Insert an SD card into the scanner, following the illustration on the rear of the scanner.
English
5