Assembly; Operation - Arctic Cove MBPM016 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-877-297-8911 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
APPLICATIONS
You may use this product for the following purposes:
 Outdoor and indoor cooling
TO CHARGE THE BOTTLE MISTER
See Figure 1.
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
overnight prior to use. When charging, a blue charge light
will illuminate on the mister. This blue charge light will go off
when the mister is fully charged.
 Unscrew the mister top from the bottle by turning
counterclockwise.
 Pour out any water.
WARNING:
Always empty the water bottle before connecting the
charger to the battery mister. Following this rule will
reduce the risk of electric shock.
NOTICE:
Do not submerge the mister top in water as this can
reduce performance and damage the mister top and
battery. If the mister top becomes submerged, store it in
an inverted position and allow it to dry thoroughly before
using or charging the product.
 Replace the mister top and tighten securely.
 Insert charger plug into input jack, making sure it is
properly connected.
 Charger can be used with normal household current of
120 V, AC only, 60 Hz.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
attachments or accessories not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

 Connect charger to power supply.
 After normal usage, a minimum of 9 hours of charging
time is required to fully recharge the unit.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
 Remove the product from the charger once it is fully
charged and ready for use.
If the charger does not charge the mister under normal
circumstances, return both the mister and charger to
qualified service center for electrical check.
OPERATING THE BOTTLE MISTER
See Figures 2 and 3.
 Unscrew the mister top from the bottle by turning
counterclockwise.
 Before first use or when refilling with water, clean the
inside of the water bottle with soap and water.
 Fill empty water bottle to max fill line below the rim of the
bottle.
WARNING:
Do not use this personal mister to spray pesticides,
liquid fertilizers, or any other chemicals. Spraying these
substances could result in serious injury to the operator
or bystanders.
 Replace the mister top and tighten securely.
 To start the mister, position the mister on a flat level
surface and press the on/off button.
 Keep misting bottle brass nozzles at least six inches away
from your face.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
 To stop the mister, press the on/off button.
5 — English